The most common problem is the problem of hot metal shredder and electrical machine, the motor in use after a long time will be short of oil, affect the use of the whole machine especially pieces machined material production line, electric heating or burning pieces processing can't drive, so the whole production line will stop to bring you is a lot of negative effects.
1. The adjustment of the triangle belt of the metal shredder triangle belt is too tight, the motor bearing is hot, the rotational speed is reduced when it is loose, and the triangle belt is easy to slide, which can affect the service life. , adjust the v belt tensioning degrees can be fixed motor base bolt loosening, with adjusting bolt to change the position of the motor on the ramp, make v-belt meet need of tightness, and tighten the retaining bolt.
2. After a certain amount of time, the metal shredder needs refueling or opening the cleaning bearing and refilling the lithium base lubricating oil. Restore the lubrication of the bearing.
3. If the metal shredder tool is not quite good is easy to cause broken knife, the status of the waste, this situation is due to the shredder in the manufacturing process of spindle rotation center and the center of the tool is not consistent, due to different heart. When the main shaft is running at high speed, if the main shaft and the cutter have different heart conditions, it will not only affect the processing material molding and the production rate of finished products, but also affect the processing effect.
4. The power line of metal shredder can not be too long or winding. This makes the motor undervoltage or undercurrent. I know that the voltage of the motor work is 380 volts, and the working current is marked on the motor nameplate. The rated current of the wire must be greater than the rated current of the motor. Otherwise, the motor will be liable to heat or burn down under the condition of undervoltage or undercurrent.
