When the template crusher produces noise, it says it needs to be repaired

The template crusher can deal with wood, wood and sawdust, and other raw materials investment, low energy consumption, high consumption efficiency, good economic benefits, the use of maintenance and other advantages. Mushroom wood grinder, especially in the edible fungus cultivation base of wood processing, mainly by cutting, installation, grinding and installation of breeze machine composition. After cutting, the particle size of the wood can be sent to the center where the grinding installation is not boring, and the collection of the air sent by the waste sawdust. Waste template crusher is a crushing wood processing machinery and equipment, I plant the production of wood, this machine is mainly composed of blade cutting, wood and other materials can be made standard in the range of 3-7cm at the mercy of the small pieces of wood, broken into pieces of wood in forestry, chemical industry, papermaking industry has general application value. There will be some noise in the application of the template crusher, and this question is not impossible to handle, although it can not guarantee that there is no noise, but we can maximize noise reduction!

• 1.In the process of building waste wood, after cutting the material after hitting the play to the inner wall of the machine, can produce strong noise, we add after wearing plate disposed against noise.
• 2.In the plate and hopper funnel drive surface, add with the housing cover damping material, can drop a lot of noise radiation surface.
• 3.The template crusher in the work, the feeding speed can not be too slow or too fast, feed too slow, but the noise will be greater, feeding too fast, the machine load increases, the production speed drop, the machine blade wear level is also big.
• 4.Can reduce the waste template crusher noise, we should often be maintained and maintained, machine bearing often filling oil, reduce noise, also can add the service life of the machine.
• 5.About the template crusher rotating parts carefully stop equalization, our equipment in each factory before stop the school balance, and then reduce the cone sleeve and eccentric shaft gap, in order to drop the oscillation intensity.