Wood powder machine has very good smashing effect on sawdust crushing. The sawdust crushing pulverizer is a new type of superfine wood powder machine which is newly developed and developed by high and new technology at home and abroad:
1. Wood powder machine should be strictly observed before the start of the machine parts of the device is not in line with the request, metal objects will not fall into the machine, first hand drive belt test run, to see whether there is a bite and roll, touch shells and other appearance, so as to avoid attacks.
2. Wood powder machine boot sequence: first open fan, after the host, stop when the main engine after the stop fan.
3. We should adhere to the uniform feeding, feed size based on the hardness of the material, hard material shall not exceed three cm in diameter, no metal lump into feed, in use process, the motor load can not be overloaded, adhere to normal operation.
4. Should often see the blade, grinding plate wear procedures, such as the blade grinding plate wear severe, should be replaced in time.
5. Fineness conditioning method:
According to the fineness request, the adjustable blade is adjusted along the axial direction. The smaller the taper blade is from the cone surface, the smaller the fineness is, and the bigger the deviation is.
Cap: cap drop test of high and coarse inside, until the cap removed.
Adjust the air volume: the air door opens small, reduces the air flow, the particle size increases, vice versa coarse, the air volume is too small, the return material nozzle is easy to powder outside.
Host: in the conditioning fan when necessary to cut casing wind leaf 2-3 tablets can improve the fineness in the feed back mouth spraying can also be used in this way, the above four measures from 20 mesh to 325 mesh.
