Plastic shredder shredded material through the air swing sorting system, the metal and non-metallic separation, the other system equipped with dust removal device, the production process to minimize the risk of dust pollution to a minimum. The equipment mainly has the advantages of high output, low energy consumption, high efficiency and uniform crushing. And in the use of the device, low noise, pollution-free, easy to operate, easy to maintain. Die steel material because it has a very good wear resistance and harden ability, produced by the shredder blades take the high-end line, commonly used are DC53, D2, SKD11, Cr12MoV and so on. The tool steel because of cheaper prices, with good toughness and impact resistance, used for some conventional plastic shredded wood shred or very easy to use, commonly used materials are 6CrW2Si and 9CrSi. For the construction environment operators set up a special shelter, install protective metal. Opposite the holes in the material to be transported are iron fences with a thickness of 10 to 12 cm, the height of which should prevent the fragments from flying over. Metal shredder equipment is the bearing cover and shaft with too tight, with the shaft bearing too tight or too loose will lead bearing overheating. However, when such a problem occurs, there will be noisy sound and obvious vibration during the operation of the equipment. In this case, we should stop the bearings, trim the friction parts, and then re-assembled as required. Belt or sprocket damage; voltage instability, the transmission part of the tension suffered by a large, resulting in the belt is too loose, a long time may produce skidding, etc. So can not be guaranteed in the case of voltage stability, the need for frequent commissioning of the transmission section.
