When the actual grinding must pay attention to the blade edge. Will these materials stop further processing and processing into waste products, to sell at normal commodity prices, so that not only can save resources, but also good for the environment to maintain the role of the national advocacy of green projects. The machine's blades are high-alloyed, meshing blades that provide excellent crusher performance for any high-hardness material. If there is any damage to the blade, if there are any, please replace it, because the blade is damaged, you do not know when they will fall off, if it falls in the material box, it will result in a set of blade All scrapping, serious time can also cause operator casualties, so that we only in the wood shredder blade material and daily production operations in strict compliance with the operating norms and diligent in checking. Although the metal shredder with low speed and high torque with strong power and shredding machinery and equipment, but because of its kinetic energy, so the effect of reducer is very important, can effectively control the speed of the metal shredder. Therefore, the maintenance and maintenance of reducer for metal shredders is also very important. Although there are many types of blades, the material chosen for the blades will vary. The most popular modern is a copper with good performance. It achieves greater wear resistance and sharpness after heat treatment. Work efficiency will be higher in operation. And can adapt to many environments, to ensure its efficiency and service life.
The so-called heat treatment of metal shredder blades is to allow them to “rejuvenate”. This can make the blade more perfect quality. General metal shredder manufacturers do not have the metal shredder cutter production conditions, so when ordering metal shredder cutter must know whether it has been done heat treatment. Only after heat treatment of the blade which only has high hardness, high efficiency, long life characteristics. Equipment used in the heat is relatively large, the heat does not go out, so that we will block the equipment, the device may smoke. In operation, we should pay attention to our equipment lubrication, fever is the main danger of our safety, it is necessary to complete our safety.
