The quality of a shredder cutter is up to his blade. The quality of the blade is determined by its material, and the material used to make the wood shredder blade depends on the material needed to shred the product.
The blade has ordinary processing, multi-blade structure and spiral surface structure of three kinds, these three kinds of feeding methods have inclined mouth feeding and flat mouth feeding. The general choice of long flat mouth feed, short wood and slab general choice skew feeding. When we feed the feeding port, we must check whether there is any scrap metal or other hard materials in the shredding material. If so, you should even clean up, to avoid the tear in the shredding machine blade when the chinks, there is every day before get off work to check the wood shredder blade group which is about to fall off the blade, if there is To change promptly. Because the blades are damaged, you do not know when they will fall off, and if they fall off in the material bin, it will result in a full reimbursement of a set of blades. Serious injuries can also result in operator injuries.
Before turning on, check whether the rotor of the blade is flexible and reliable and turn the wheel with your hand. Whether the direction of rotation of the wheel is the same as that of the arrow of the machine or not, whether there is a collision in the broken room or not, and whether the blades of the power machine and the shredder are lubricated well. Work, always pay attention to the operation of the shredder blade, if you find there is noise, vibration, bearings and the body temperature is too high, the phenomenon of jetting out to promptly stop the inspection. The shredder should be allowed to run idle for two minutes after starting to ensure that the motor starts up normally. In the process of feeding should try to be uniform, to avoid concentration of materials caused by excessive load on the device.
