The shredder from components to appearance is a new transformation, and also produced a lot of reserve use, these are needed to establish favorable conditions to take liquidity, the suitable quantity of this type is very much, regardless of capacity, power, size and shape are all designed and manufactured to meet the increased yield and task demand. The modernized transformation is to surpass continuously in the change of science and technology, and the more novel form is important. In the structure of the old equipment in time to replace the old, damaged equipment, become a part of maintenance, greatly improve the utilization rate of the production process closely, set lines, and automatic synchronous management at the same time, saving time and conducive to production.
Tearing machine maintenance Narration:
1. Check and clean up in time. After the end of every day, the machine should be cleaned in time to check the wear of all parts screws and the wearing parts such as claw, sieve and so on.
2. Grease, is the most common type oil cup on the bearing cover assembly. In general, as long as every 2 hours to cover the oil 1/4 turn, in the cup can be pressed into the bearing grease. If it is a closed bearing, 1 grease can be added every 300 hours. After long-term use, if the grease is deteriorated, the bearings should be cleaned and replaced with new grease. When the machine works, the bearing must not exceed 40 degrees. If the bearing temperature continues to increase under normal working conditions, the reason should be found out and the failure should be eliminated.
3. Carefully cleaning the raw materials to be crushed, and strictly prohibit the inclusion of metal parts such as copper, iron, lead and other metal parts and large stones into the comminuted chamber.
4. Do not increase the speed of the tearing machine at will, generally allow the difference between the rated speed and the rated speed of 8%-10%. When the tearing machine and the larger power machine work, we should pay attention to the control of the flow, and make the flow uniform, not to be quick and slow.
