Home >
Industry news > The screen has a great influence on the load of shredder
The screen has a great influence on the load of shredder
Industrial shredder equipment for all kinds of metal materials, plastic and tangling garbage pieces is very good, some users in the process of production of the occasional card reaction phenomena, shredder equipment in operation, under the condition of load will also increase, in the scrap metal processing industry, metal material is relatively is also different, so will produce fluctuations, so when the switch to a different screen mesh, the shredder equipment load has a great influence
The motor capacity shall be 40 kilowatts when the shredder device is used to screen the diameter of 1.2mm. The motor capacity shall be 30 kilowatts when the sieve diameter of the sieve diameter is 2 mm. Change the sieve hole diameter of 3 mm in diameter, the motor capacity should be 22 kw, otherwise it will cause certain waste. If the device is over loade our has its own way to detect: 1. Contact point: the gauge indicates the material position in the cavity, which is known as the load. 2. Weigh the conveyor belt conveyor with belt scale. 3. By calculation, the circulation load of closed circuit system is obtained. The current in the motor circuit of the shredder device is tested and the current is controlled at about 85% of the rated current. In many pieces, only commonly detection control granularity of the final product of the last paragraph of the load, the shredder is usually in a closed loop system, its into the shoes including former shredder to quantity and cyclic load.
