After a long period of work, the wood shredder will generate heat. What causes this problem?
In the operation process of the plank tearing machine, the sound of friction and the obvious swinging phenomenon will be accompanied by the equipment. At this time, the operator should stop the equipment, disassemble the bearing, first repair the parts of the friction, and then assemble the bearing of the wood shredder equipment again according to the requirement.
During the working process of the plank tearing machine, it is necessary to ensure that there are no other tearing impurities in the material to be tore, which should prevent the hammer from impact after the impact of these impurities. On the other hand, it should be prevented from damaging the sieve plate after the tearing material is torn in the tear chamber. The whole tearing effect. There is enough air quantity to ensure that the air volume has a good perforation speed to the sieve hole, so that the material after the tear can be removed through the sieve hole to eliminate the speed of the sieve plate, and enough air volume can make the rip material and impurity separation. The purpose of improving the feeding device is to keep the broken material into the plank tearing machine as far as possible to keep the feed uniform as far as possible, and to keep the relative stability between the production capacity of the equipment and the production current. It also requires that the feed flow be adjusted accordingly to ensure that the working current of the wood shredder is always stable. From the working requirements of the wood shredder equipment, the advantages and disadvantages of the feeding device directly affect the torn effect of the equipment.
