For the metal shredder, cleaning the iron in the shredding chamber is the most dangerous job. Eliminating the choking iron with incorrect methods may lead to serious personal accidents. Therefore, these need to be very careful. Compared with the conventional method, the hydraulic cavity cleaning system will greatly reduce the cleaning time and save manpower. Because the system can remove the safety of iron blocks, this method is recommended.
When the iron material enters the shredding chamber, the tension spring of the outer ring of the metal riper equipment allows the adjustment sleeve and the supporting sleeve to be raised to avoid damage to the metal shredding machine. After the material is shredding the cavity, the adjustment sleeve and the support sleeve are immediately returned to the normal operating position. Sometimes when the iron is too large, it will be stuck in the shredding table, causing the metal shredder to be bored.
When the iron material is stuck between the shredding wall and the rolling mortar wall, the supporting sleeve has to overcome the tension of the tension spring fixed on the frame in this range. The effect of the spring force on the support sleeve and the adjusting sleeve makes the iron cleaning work very risky, as the high pressure spring group has the trend of returning the bearing sleeve to its original position on the rack during the process of iron cleaning.
