Shredding machine equipment failure needs your attention in time, if the output of the shredding machine is found to drop, and when the raw material is constant, check whether the valve is in place, the pipe has no air leakage and so on. The plug is also a common fault. There are 4 kinds of possibility: 1. may be the design problem of the body. The 2. is that the raw materials are put too fast. 3. is the discharge of the pipe is not smooth. 4. it is possible that the moisture content of the raw material is too high. When working, the bearing should be paid special attention. When the temperature is too high or there is noise, etc. Generally, the lubricating oil or the bearing cover and the shaft are too tight, the harder the hardness of the material is, the harder it is to crush, the broken effect is not good, and the speed of breaking is slow. The second is the requirement for the fineness of the shredding. The higher the fineness requirement, the longer the working time is required for the shredder to process the material reciprocally. Third dry humidity of material. The humidity of the material is too large, so that the material can be blocked in the crusher, and the relative shredding ability can be worse. Then it becomes the material of the hammer and the plate of the crushing equipment. If the material of hammerhead and plate is quite poor, the hardness is not strong enough, and it is not good enough to wear. This may affect the ability of crushing, and it is not easy to achieve the desired requirements. Especially the hardness of the rip material. The hardness of the material determines the speed of the shredder.
