Many people because of lack of experience, the initial use of Raymond mill maintenance, improper use. This is all because there are misunderstandings in the maintenance and use of the Raymond mill. Can not underestimate the harm caused by improper maintenance of the new machine, ranging from just the machine damaged, even worse, it threatens the lives of drivers and passengers. The following points to note:
Feeding to be appropriate:
After running the machine at no load, at the time of loading and unloading the Raymond mill, start with not feeding too much, first reduce the burden on it and give the right amount of material to run smoothly on the Raymond mill for 8 hours After that, Raymond Mill can be determined to work normally, and the machine has no abnormal noise. The pipes are free of air leakage and can only be put into operation normally at this time, and the materials can not be given too much. Slow addition.
Watch the working status of Raymond mill roller at any time:
When the grinding roller device is used for more than 500 hours, when replacing the grinding roller again, the rolling bearings in the roller sleeve must be cleaned, the damaged parts should be replaced in time, and the refueling tools can be manually added with a grease pump and grease gun. Roller bearing refueling once per class, the host center bearing once every 4 classes, blower bearings plus once a month. The maximum temperature of the bearing should not exceed 70 ℃, found overheating bearings, cleaning bearings and bearing housing should be opened and other accessories to clean once.
Pay attention to Raymond mill abnormal noise:
In Raymond mill operation, the operator should pay close attention to the sound of the various parts of the machine. Once you find the car has abnormal sound, first of all to accurately determine the sound from inside the machine or outside the machine. If you come from within the machine, it should not matter; if it comes from outside the machine, you should stop to check.
