Firstly, the tire shredder starts the equipment after the power supply is switched on. After confirming that everything is normal, the tire shredder preheates by idling. Secondly, the material that needs to be shredded is put into the tire shredder. When the material in the cutter chamber is broken completely, new materials will be put into it again. If a fault occurs at work, the equipment must be shut down immediately and the power supply cut off for further treatment. When the fault is resolved, the equipment can be restarted.
Then when the work is finished, turn off the switch, cut off the power supply, then open the knife chamber and the bunker, clean up the remaining material and close the bunker, remember to tighten the fixed screw. Put the broken plastic into the woven bag and put it in the designated position of the workshop to clean up the equipment and the surrounding ground hygiene.
In the process of operation, do not put too much material in one time, so easy to cause stuck, or burn the motor. During the operation of the equipment, it is strictly prohibited to extend the hand into the shredder for operation, so as not to cause injury. It is strictly prohibited to put metal, stone and other hard and hard stuff into shredding, so as not to cause blade damage. Kettles, scissors, blades and other sundries are strictly prohibited on the equipment to prevent foreign bodies from falling into the inlet and damaging the equipment. Regular lubrication and maintenance of operation parts.
Tel : 0086-371-67666660 E-mail : Admin@sgzgchina.com Cel : 0086-13523465141