The wedge iron fixing bolts of the gasoline drum mill plate are easy to loosen, and in addition to the operator's daily inspection, each fixing bolt must be tightened each time a minor repair is planned. The small repair interval of the gasoline drum mill can generally be 30-40 days.
The following items should be noted when using a gasoline drum mill. Before driving, carefully check all the fasteners of the crusher for looseness. Sufficient lubricating oil should be added to the arc surface of each bearing and bracket. There must be no block or other debris in the crushing chamber. The crusher is not allowed to start with load. After the idling is normal, the material can be fed. The feeding should be uniform, avoiding feeding from the side, preventing the load of the crusher from being abrupt or the one-side load is too large and the elbow is damaged. board. Always observe the temperature of the bearing during work. The temperature of the bearing should not exceed 70 °C. If it is found that too much material blocks the crusher and causes automatic stop, the motor should be turned off immediately. The material must be taken out before starting again. Otherwise, it will be started. Damage the motor or other parts. Stop the feeding before stopping, and then turn off the motor after all the materials in the crushing chamber are discharged.
Tel : 0086-371-67666660 E-mail : Admin@sgzgchina.com Cel : 0086-13523465141
