After customers buy industrial shredder, in practical production, probably because of feeding too fast too fast, cause industrial shredder production was blocked, so industrial shredder plugging of the problems, how to solve?
In the process of industrial shredding, if it is not cleaned up for a long time, it is easy to cause the industrial shredder to be blocked. There may not be much impact in the early stages of the blockage, but it will be too late when the industrial shredder fails, thus affecting productivity. Today hongyi mechanical make up to give you an analysis of the possible causes of blockage caused by industrial shredder.
Industrial shredder failure requires you to pay attention to in time, if it is found that industrial production shredder is reduced, and the raw material is constant, check the damper is in place and pipes with and without air leakage, etc., industrial shredder jams are common faults, the likelihood has four kinds: 1: may be the body design problem; Two: the raw material is put in too fast; Three: the pipe of the discharge is not smooth; 4: possible raw material moisture content is too high, it is important to pay special attention to the bearing at work, its temperature is too high, or has the problem such as noise, are generally lubricating oil or the matching of the bearing cover and shaft tight, just can have this kind of situation.
Industrial shredder as long as pay attention to the usual maintenance, fault scenario or less, except industrial shredder quality closes nevertheless, of course, it is worth noting that the maintenance but too, such as lubricants add too much at once, cleaning too hard-working, but its use have hurt! ,
As long as you understand the reasons for the blockage of industrial shredder, you can find the right solution or avoid the industrial shredder and avoid the machine damage caused by the blockage!
We are the world's leading manufacturer of industrial shredder! If you need to buy industrial shredder, welcome to inquire!
