Triangle shredder equipment is the reason why choose to use is due to its ability to reach the normal consumer efficiency is also very easy to check the wear and tear, check the wear of the belt only needs eye, ears can be done, when the belt with the triangle Trimming the shredder shield creates a "ticking" that is easily recognizable and can cause significant wear and tear on the fabric of the outer belt of the V-belt to shorten the service life of the V-belt, although friction is Of the ticks are easy to distinguish, but sometimes the operation of the shredder may overshadow the sound, which is not recognized by the user. Therefore, we should enhance the visual inspection of the shredder. After the visual inspection, we can also find out that There is a collision between the plate and the V-belt.
Visual inspection there is a serious factor in the formation of the triangle belt wear, that is, the pulley tilt, the common problems with the naked eye is difficult to detect, we need to use a ruler to assist the ruler direct contact with the shredder Pulley, and then turn the two pulleys, then pay attention to the change between two pulleys and straightedge, if the ruler and pulley can not contact, clarify that the shredder equipment uranium bending or pulley swing The phenomenon.
Another requirement we note is that due to the flexibility of the V-belt, we allow the pulley to be out of alignment, but also to a limited extent. Beyond this limit will not meet the design requirements, resulting in the formation of V-belt wear. There is also a way to measure whether the pulley can be tilted. We visually inspect whether the edge of the groove of the shredder and the belt can be in a straight line. If the belt is bent into or separated from the groove, Dislocation of the wheel alignment.
