Several problems that should be noticed during the use of wood crusher:
The wood crusher can ensure that the chassis is stable and the line connection is normal. It can start work, and then do not rush to discharge. Look at the damage machine is not a normal job. At this moment, it can investigate the sound of the destruction machine is not normal, noise Whether it is too big or not, whether the starting time is too long or not, if it is possible to detect if the starting current is normal or not, etc., it is not suitable for the motor parameters. In the investigation of the normal operation of the wood crusher, the material is gradually discharged. When the material is discharged, it is necessary to investigate whether the material is fed properly. When investing in wood, it is necessary to pay attention to the steady and balanced rate, and other factors should be based on the size of the lumber. And the degree of boring to determine the feed rate, such as wood with a higher moisture content, the rate of input is slower, in fact, we advocate that the wood should be dried as much as possible drying or drying in the future and then destroyed. The continued stable feeding is an important factor in the resolution of the working power. In the case of fixed machine and environmental wood, safe and continuous feeding can improve the unit output value of the wood shredder. The wood is probably dried as much as possible. The wood with too much water content directly affects the destructive power of the wood crusher, which we have previously analyzed. Timber should be pure and free from impurities such as iron block stones, otherwise it will cause certain hazards to the blades of the wood crusher and hammer nets.
