Have a general understanding of the factors that affect the production capacity of the impact crusher. In general, there are many factors that affect the production capacity of an impact crusher. There are generally five-factors:
1. Hardness of the material: The harder the material is, the more difficult it is to make sand, and the more serious the wear of the equipment, the slower the sand production and the lower capacity. Therefore, we need to pay attention to the selection of materials.
2. Composition of materials: The more fine powder contained in the material before the impact crusher influences the sand production, because these fine powders tend to adhere and affect the transportation. Therefore, for the fine powder content, the material should be sieved once in advance and the powder should be filtered out of the material as much as possible so as not to affect the normal operation of the impact sand making machine.
3. The fineness of the crusher after crushing the impact crusher: The fineness requirement is high, that is, the finer the material required to make the sand, the smaller the sand production capacity, which depends on the specific requirements. If there is no special requirement, the general The fineness of the material is set to be fine.
4. Viscosity of the material: The greater the viscosity of the material, the easier it is to adhere. The material with high viscosity will adhere to the inner wall of the sand chamber in the red star impact crusher. If it cannot be cleaned in time, it will affect the impact system. The sand machine's working efficiency may also affect the normal operation of the impact sand-making machine. Therefore, when selecting materials, it must be noted that the viscosity of the materials is not too large.
5. Humidity of the material: When the moisture contained in the material is large, the material is easily adhered in the impact sand-making machine, and it is also easy to cause blockage in the conveying process of the blank material, resulting in a decrease in sand-making capacity. To solve this problem, we must first strictly control the humidity of the materials when the materials are selected. If the humidity of the selected materials is too large, the percentage of moisture in the materials can be reduced by using sunshine or air drying.
