In order to ensure the quality of tearing and normal production, the equipment of metal shredder should be fed uniformly, and the overload of motor should be avoided to ensure the normal operation of the equipment. In addition to checking the fastening and loosening of the parts occasionally, it is also necessary to pay attention to the scratching of the worn parts. If the scratch is serious, it should be replaced in time so as not to damage the main parts. What are the requirements of the metal shredder equipment in the work?
The feeding granularity should not exceed the required size, and the feeding should be continuous and uniform, so as to prevent the phenomenon of blocking up. Check the connecting bolts, especially the square bolts with fixed teeth, to prevent loosening. Always check the temperature of the bearing, and the temperature rise of the bearing bush should not exceed 30C at room temperature. Each shift lubricates each bearing bush, large and small gears and special-shaped gears twice to ensure that the lubricating oil in the bearing bush is sufficient to reduce the overbreakage of the sleeve Bush and gear. When the power is suddenly cut off, the power supply of the motor must be disconnected to prevent sudden calls from accidents. Then take out the unripped material from the metal shredder to prevent the metal shredder from cutting off the safety pin due to heavy load during startup.
Tel : 0086-371-67666660 E-mail : Admin@sgzgchina.com Cel : 0086-13523465141
