The correction method of the main shaft of the waste woven bag shredder:
1. Use the press to proofread the fourth section of the spindle. Firstly, use the four-jaw chuck to clamp the fifth section, select the base support structure to support the third section, and locate the base of the fourth section.
2. Next hit the base eye, and then use the ejector pin to hold, remove the base frame, the first and third sections of the refined car list, rough car vacancies are some.
3. Finally, the spindle head-changing process, using the four-jaw chuck to clamp the first paragraph of the list, choosing the base support structure to support the fifth paragraph, and locating the base of the fourth paragraph. Hit the base eye, then use the thimble to stand up, remove the base frame, and finish the car for fifth periods. This is the way of proofreading the whole spindle. If you have any unclear locality in operation, you can contact our company's Shuguang technical department at any time to make accurate proofreading.
Tel : 0086-371-67666660 E-mail : shuguang_mill@163.com Cel : 0086-13523465141
