It's not difficult to find suspension shaft chamber in tire shredder machine gathered a large number of oil sludge, this may be due to outlet clearance is too large, led to the suspension shaft inner chamber pressure is less than the milling cavity pressure, causing dust into the suspension shaft inside the cavity, in the long term a lot into the accumulation, so this text is about how to solve this situation.
Well,we open the milling chamber, using hand plate found some roll alternately rotation and not turn, roll and grinding ring is collapse, caused by poor lubrication analysis of roller bearing is at this time we should be in accordance with the instructions on the technical requirements of processing, processing after the nondestructive flaw detection for each column pin;
In order to ensure the uniform distribution of the various column pins, it is necessary to reprocess the cylinder pin hole of the wheel and compressor flywheel.
Ensure the assembly precision of the axle machine and the concentricity requirement of the motor and compressor, make a reasonable disassembly plan and tighten the torque wrench evenly when fastening the pin. This will eliminate the risk of the device.
So it's not scary to say that the equipment is malfunctioning, but what's scary is that we don't understand the principle that we don't fix it, we panic.Shuguang helps you to dispel this concern.
Shuguang has nearly 30 years experience in manufacturing shredding equipment and recycling system for scrap tires, metal, wood, solid waste. We are professional in tire shredder, metal shredder, wood shredder,solid waste shredder and e-waste shredder.Welcome to cantact us.
Factory Address: Longjiang West Road, Shangjie District, Zhengzhou City
Contact number: +86-371-67666660 676667
Mobile phone: 0086 13523465141
After-sales Service Department: 0371-67666667
